Top Tips on How to Replace A Windshield
When there is a chip or crack on your windshield, chances are high that it will continue becoming bigger and therefore attractive and dangerous. As you probably know, when you take your car to a repair shop for new windshield, it can be expensive and sometimes unnecessary, and this is why you should learn how to replace the windshield by yourself. This article is going to provide you with more information about the best tips on how you can replace the windshield.
The first thing that you will do when you want to replace the windshield is remove the damaged one from your vehicle. For you to successfully remove the windshield, it is important to remove the rubber trim, peel the gasket from the groove and then remove the clips. Using a razor, cut the urethane seal so that to separate the windshield from the pinch-weld. You will realize that it might be a challenge to cut through the urethane seal because it is adhesive and very strong. It is important to get the urethane seal from inside so that you do not break the glass and have a mess. What you should do next is lift the windshield using the help of another person. After lifting the glass, put it carefully on the ground and it is a good idea to place a towel beneath the old windshield. This is going to avoid the mess of shattered glass where you have parked your vehicle or in the garage.
Before installing the new windshield, you should prepare the pinch-weld by using sandpaper to remove rust from it, passing water on it and then brushing it to clean away contaminants. Apply a layer of urethane primer to the black band around the perimeter of the windshield so that you can install your new windshield. To read more about how you can install your new windshield, visit the website of Windshield Guru.
Before you start driving, it is important to give urethane time to dry which takes about 24 hours. After you have installed your windshield glass, the next thing is to install a window gasket and it is important to start at one end of the gasket pressing it into the groove throughout the entire perimeter of the windshield. The final step is for you to replace the trim around the windshield only if urethane has dried completely. If you follow the above steps, then you are going to replace your windshield within no time. If you’re interested in finding out more about the other best Do-It-Yourself windshield replacement tips, click here.